Also to know is, how do you set up Energenie?
Remote Controller Pairing1. Pair with an Energenie hand controller as follows: To set the unit into pairing mode, press and hold the button on the front of the relay unit housing for 5 seconds or so until the lamp on the front starts to flash at 1 second intervals.
Also Know, how do you program a remote control socket? Plug the Remote Sockets(s) into the wall socket(s) and switch on the mains supply, the red LED will flash every second. Press any ON switch on the Remote Control for approximately 2 seconds and the Remote Socket(s) will learn the code. The LED will stop flashing top confirm the code has been accepted.
Also to know, how do I reset my Energenie plug?
Press and hold the Green button on the socket until the RED LED lamp flashes at 1 second intervals. Keep pressing the button until you see it brefly flash more quickly indicating full reset has occurred. To replace the hand controller battery, remove the cover and existing battery.
How do I program my Energenie remote?
Press and hold the button on the socket unit for at least 5 seconds unit the light on the unit flashes slowly. A new key can then be programmed in by pressing and holding the required key 1,2,3,4 on the remote control until the light flashes quickly and extinguishes indicating programming complete.
